BY: PhanatikZ32 Composed by: 300ZXttZMAN Z32 COILOVER INSTALLATION Tools needed: – ½” ratchet – 3/8″ ratchet + 3/8″ extension – 10mm socket – 14mm socket *deep* – 17mm socket – 17mm wrench – Phillips screwdriver – BREAKER BAR!!! – Jack + Jack stands – PB Blaster or other rust penetrant spray NOTE: this installation is […]
Z32: Replace a Wheel Stud and Install Hubcentric Wheel Spacers
by: rockchucker After replacing all of my suspension components on my 300ZX I found that my wheel offset was not enough to bring my front wheel flush with the body… So I measured the distance it was off and ordered a Version 1 Ichiba Hubcentric 15mm spacer kit with new longer wheel studs. The version […]
Z32: Headlight Conversion – High / Low beam lights together
By: z32pilot62 Composed by: 300ZXttZMAN When you put HID’s in your headlights and you are on the highway, it’s very nice to not have to turn them off every time you turn on your high beams. This also increases their life… In the image you will notice that the YELLOW arrow points out the factory […]