5th/6th-Gen Maxima – How to Reset ECU

How to reset ECU in 5th and 6th Generation Maxima’s

1. Turn ignition switch on and wait about 3 seconds.

Repeat the following steps (2a and 2b) procedures quickly five times within 5 seconds.

2a. Fully depress the accelerator pedal (HARD).
2b. Fully release the accelerator pedal.

3. Wait 7 seconds, fully depress the accelerator pedal and keep it for approx. 10 seconds until the CEL starts blinking. (here is where i think you can get a code from this.)
4. Fully release the accelerator pedal (while the CEL is still blinking)
5. Wait about 10 second.
6. Fully depress the accelerator pedal and keep it for more than 10 seconds.
7. Fully release the accelerator pedal (The CEL light will continue to blink).
8. Turn ignition switch to “OFF” position and now you can start the car. The CEL light should be gone.