Sunroof/Window Initialization Procedures

Applied Vehicles: Infiniti & Nissan vehicles Difficulty Rating: Estimated Labor Time: Not Applicable Estimated Total Cost: Not Applicable Find related tutorials and information on your vehicle in NICOclub’s Nissan Forums & Infiniti Forums

Window Operation

If the windows will not operate in the Auto-Mode and any of the following conditions have occurred, the windows should be initialized:

• Battery cable is disconnected
• Power window switch connector is disconnected
• Power window regulator is replaced
• Power window motor is replaced
• Window glass is removed
• Window glass run rubber is replaced
• Power window fuse is blown

Window Initialization Procedure

1. Turn the Ignition switch “ON”.
2. Open the window more than half way using manual-switch (NOT Auto-Mode) operation.
   • NOTE: If the window is already open more than half way, go to step 3.
3. Close the window using the manual-switch operation and hold the switch UP for 3 to 4 seconds after the
   glass reaches the fully closed position.
4. Confirm the window you are working on is operating properly.
5. Then, confirm all other windows are operating properly.

↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔↔

Sunroof Operation

If the sunroof does not operate properly, and any of the following conditions have occurred, the sunroof should be initialized:

• Battery cable is disconnected
• Sunroof motor is replaced
• Sunroof anti pinch function is activated for more than 5 seconds continuously
• Sunroof auto-open and auto-close function does not operate

Sunroof Initialization Procedure

1. Fully close the sunroof. If necessary, press the Close switch several times until the roof is completely closed.
2. Press and hold the Close switch for 3 to 4 seconds.
3. Confirm the automatic operation of the sunroof works properly.