materials:
a friend, knife, heat gun, screw driver, old throttle cable or piano cord, heavy duty glass adhesive, the replacement glass, and OEM or aftermarket weather stripping for the outer glass.
DIY LED Sidemarkers
***DO THIS AT YOUR OWN RISK!***
This process is irreversible so be prepared to buy new sidemarkers if you don’t like the result or if you mess up. This will be a long article, but be sure to read it through completely before you begin.
Installing Digital/HUD Gauge Cluster
Overview:
Installing a digital/HUD cluster is a way to class up your s13, full of that late 80’s early ’90s style from the golden age of Japanese autos.
Difficulty: **
Time: 1 hour
Cost: $20-$50
Convertible: Rear Strut Removal
The rear struts are a pain to get to because of all the bracing that’s in the way. The easiest way to get to the strut towers is to remove the rear seat.
Difficulty: ***
Time: 2-3 hours
Cost: n/a…
float_6969’s Official CA18DET upgrade guide
Well I think our little CA section has finally grown large enough that I would like to start to create a generic upgrade guide to direct our new members towards so that they have direction with their upgrades on the CA.
As we all know (or you will soon know when you get your CA), stock is NEVER good enough!
Installing Cruise Control for SR20DET Swapped 240sx
The car is a 1990 s13 with a redtop SR. Parts:KA throttle bodyShort piece of electrical wire (about 1.5 feet) Procedure:First things first, swap over the throttle body from your old KA onto the SR. Next, there are two different ways you could go. What seems like the easiest is to use the KA throttle […]
Installing an FPR on SR20DET
Make sure you have suitable line to connect your FPR.
You don’t need a rail adapter with the Megan racing unit, just make sure to use an o-ring to fill the gap.
Other than that, you should have everything that you need!
Megan Racing Coilover Install (S13)
Installing a fully-adjustable suspension is probably one of the best performance upgrades available for an s-chassis. It can also be a daunting task considering the necessity for proper adjustment to achieve the type of handling characteristics desired.
Installing Greddy eManage Into an S13
A straightforward install, most are just tap-ins, apart from these wires. Follow closely, otherwise the car will not start. Please Make sure you disconnect the battery, and while disconnected push the brake pedal a few times to clear ECU. Please only install if you are experienced, or very very confident with wiring…
Installing Greddy Rocker Arm Stoppers on an SR20DET
Rocker Arm Stoppers (or RAS’s for short) are a must for any SR20DET. They’re pretty cheap, easy to install, and will prevent bent valves. Think of this as an insurance policy for your SR20.
- « Previous Page
- 1
- …
- 7
- 8
- 9
- 10
- 11
- …
- 18
- Next Page »