NICOclub

The Nissan and Infiniti enthusiast community - Repairs, modifications, resources and much more!

Search NICOclub.com
search

Intercooler Proctector

by

In this article we will performing some preventative maintenance to prevent damage to the fins of your intercooler by applying a thin screen over the housing. This is a simple cost efficient DIY that can save you from costly damage in the future. Skill Level 1 of 5 Time Required

240SX Door Panel Fabric Replacement

by

In this article we will be replacing the fabric on the door panels. This can be damaged over time or you may be looking for a new look to match your interior mods. Skill Level 3 of 5 Time Required 1-2 Hrs. (Depending on adhesion rate of the glue used) Tool and Supplies -Phillips screw […]

240SX Headlight Refinishing

by

In this article we will be repairing the glass style 96 240SX headlights that have faded. This is a fairly straight forward task and can make your car look much better. Skill Level 2 of 5 Time Required ~1 hour Tools and Equipment -Fine grit sand paper-both 800-1000, and 1500+-Clean water (in a 1qt. or […]

Rusted Hatch Repair for S13 Fastback

by

If you have an S13 fastback with the stock foam spoiler – or the rust sponge as it is often referred to – you probably know what has been going on for the past 15+ years under there. You COULD just find a clean hatch to swap out, but if you don’t have access to […]

240SX Dashboard Finisher Remodeling

by

In this article we will be repainting and refinishing the dash trim to have a more unique interior. This will work on most Nissan 240SX, Sentra, Maxima, Altima, and Versa models that have removable trim panels. Skill Level 2 of 5 Time Required 30 Mins. – 24Hrs. (Depending on amount of trim to be painted, […]

S14 Replacing The Main Switch Bulbs

by

In this article we will be replacing the light bulbs in the little push switches in the dash of your S14. Skill Level 4 of 5 Time ~2-2 1/2 hours Required Equipment – Switch bulbs: Radio Shack P/N 272-1092– Small flathead screw drivers or the like to pry open the switches– Scissors HAZARD SWITCH Hazard […]

S13 In-Dash Cupholder Install

by

In this DIY article we will be retrofitting a mid 90’s cupholder for in-dash installation in an S13. Skill Level: 2 of 5 Time Required: ~1-2 hours (Depending on the glue used) What you will need: – Cupholder from mid-90’s Altima – Philips screwdriver– Dremel with cutting wheel– Safety glasses (very important when working with […]