NICOclub

The Nissan and Infiniti enthusiast community - Repairs, modifications, resources and much more!

Search NICOclub.com
search

Nissan Fuga Owners Meet… in Japan! (Part 4)

by

Article Series

A short time later, a crew of some other tuners showed up. One car was especially nice, a Z32 Fairlady. There was also an S13 coupe with bolt on overfenders, but under the hood was pretty nasty looking. There were a couple JZX 100 Mark II, a Celsior and something else. Some nice, some not […]

Nissan Fuga Owners Meet… in Japan! (Part 3)

by

Article Series

Pretty much all the Fuga owners had done tasteful modifications. Most had some kind of car audio/video set up, or LED lighting inside and outside the car, but nothing extreme or over the top. After some more small talk, photo taking, coffee drinking, runs to the toilet, getting food at the convenience store, it’s decided […]

Nissan Fuga Owners Meet… in Japan! (Part 2)

by

Article Series

Another guy I spoke with had a 350GT that had quite a bit of work done to it. It was dropped on Tanabe suspension, riding on a set of one-off 21 X 9.0J wheels wrapped in 245/30 rubber. Under the hood, he runs a Group M’s intake with a real carbon fibre airbox, and a […]

Replacing your Nissan 240sx Convertible Top – Part 3

by

Article Series

Now that you have your top off, you get to do the fun job of prepping the new top and window to go on. First thing is to finish pulling the staples out of the rear window after you make your guide lines for the top edge of the tack strip. This is the most […]

Power Window Reset for later-Gen’s

by

These instructions can be utilized to reset the power window modules for newer-generation Nissan and Infiniti products Reset Power Windows: If the power window automatic function (closing only) does not operate properly, perform the following procedure to initialize the power window system. 1. Push the ignition switch to the ON position. 2. Close the door. […]

Install a PCV Catch-Can to Your Versa

by

SO I decided to install an in-line catch can post PCV valve. I purchased all my materials at my local ace hardware store. Using a compressor’s water/air separator, and some 3/8ths inch fuel line, some fittings and ring clamps, I now have an inexpensive system to remove oil and other contaminates from re-entering the intake […]

How to Install a Dash Kit

by

Step 1: Check to ensure that you have the correct piece and that it fits. [img]http://i413.photobucket.com/albums/pp215/ashleycabral/IMG_2174.jpg[/img] Step 2: Warm up each piece. You can either put them on your vents with the heat on high (warm) or use a hair dryer. [img]http://i413.photobucket.com/albums/pp215/ashleycabral/IMG_2171.jpg[/img] Step 3: Use alcohol pad to clean the area. [img]http://i413.photobucket.com/albums/pp215/ashleycabral/IMG_2172.jpg[/img] Step 4: Use […]