NICOclub

The Nissan and Infiniti enthusiast community - Repairs, modifications, resources and much more!

Search NICOclub.com
search

Altima 3.5 Injen Short Ram Intake Install

by

Okay, first off, I’d like to say that the installation is quite simple and straight forward. If you have basic mechanical skills, it shouldn’t take more than 40-45 minutes tops. I have a lot of experience with installing intakes, exhausts, headers, etc., and it only took me 35 minutes, but that’s because I took pics […]

DIY guide to lowering a Nissan/Datsun pickup truck

by

Many people tend to be curious as to the lowering of their pickups when they get them. This is the simple process to lower a Nissan or Datsun truck. It covers models all the way from back in the Datsun days through the hardbody days. The process uses lowering blocks in the rear and adjusting […]

Z32: DIY JDM Taillights

by

How to convert your 300zx (Z32) USDM taillights to JDM taillights This isn’t meant to be a “How-to” write up. But you can follow it at your own discretion as you may break your tails. I did, but I had a back-up set. Tools Needed: Paint Brush Oven or heat gun Terry or microfiber cloth […]

350Z and G35 ECU reset procedure

by

How to reset your ECU and perform the Throttle Pedal Release and Idle Air Volume Learning procedures on an Infiniti G35 and the Nissan 350Z. Before attempting any of the following procedures, it is advisable that you read through the instructions thoroughly and familiarize yourself with them. A stop watch or an analog clock with […]

Refinishing the Headlights on an Infiniti I30/Nissan Maxima

by

How to refinish your headlight to make them look brand new. This DIY article will show you how to remove the haze from your I30/Maxima headlights. Tools/Materials Needed: Wet/dry sandpaper in 1000, 1200, 1500, and 2000 grit Car polish (not wax, but a fine cut polish) Soft cloth or those blue autozone paper towels Spray […]

Installing a SPC Rear Camber Kit and Toe Bolts on an Inifiniti G35

by

This article will show you how to install a SPC rear camber kit and make modifications for Toe bolts. TOE BOLTS: Tools used: 19mm socket 17mm socket breaker bar 2 socket wrenches sharpie Dremel #115 dremel bit Jack & Jack Stands Jack the car up and place jack stands. Loosen stock toe bolt. Using hydraulic […]

How to rebuild your starter

by

In this article we will be rebuilding a starter for an SR. This can be a relatively straightforward and relatively inexpensive repair, if you have the time and patience. Skill Level 4 of 5 Time Required 25mins – 2hours.(the first time it takes longer) (not including R&I) Tools and Equipment -8mm, 10mm, 12mm socket -Flathead […]