Now that we have the creature comforts covered, let’s get down to the important part, the mechanics. First of all, the Quest does not drive like a van. It drives like a very nimble, albeit large, car. Steering is responsive and accurate and it corners without the typical nauseating body roll. I think the thing […]
2010 LA Auto Show (Part 2)
NICOclub covers the new offerings from Nissan and Infiniti at the 2010 Los Angeles Auto Show.
Painting VQ35DE Valve Covers
Applied Vehicle(s): Vehicles w/ VQ35DE Engine Difficulty Rating: Estimated Labor Time: 2½ hours Written By: tollboothwilley Estimated Total Cost: $20.00 Find related tutorials and information on your vehicle in NICOclub’s Nissan Forums & Infiniti Forums So I have a (almost) new set of valve covers that I’m installing due to the leaking oil in cylinders […]
NICOclub Staff – SHIFT_COUPE
Staff Bio Tyler (SHIFT_COUPE) Altima (Coupe) Moderator I was born and raised in Bethel, Connecticut where I am currently attending Western Connecticut State University to finish up my Bachelors of Business in Management Information Systems. I hope to continue furthering my education with a Masters in Business Administration soon after. My first car was a […]
Altima Coupe Smoked Taillight Overlay Install
Click Here for a How-To on removing your taillights– Clean the taillight you will be working on before proceeding – Using a bottle of a soapy water solution, spray the taillight down. Do the same for the vinyl overlay once you have peeled it from the backing. This ensures a slippery surface so you have […]
Removing Altima Coupe Chrome Grill Inserts for Painting
For those of you who plan on painting the chrome grill inserts, here is a quick how-to. I just got the plastic pieces off today. I took a few pictures for those who havent done it yet but are planning on it. The key to all of this is patience. Removing the Inserts Take a […]
Nissan Altima: Install the Stillen Front Strut Tower Bars
So my new Stillen Strut tower brace came in and I was excited as hell to install it. At first I wasn’t going to do a full write up on it since Stillen’s instructions are pretty clear but also includes the the instructions to install it on the 09 Maxima but I know that there […]
Altima Coupe: Installing LEDs In The Center Vent And Cupholders
My philosophy with any automotive accent lighting is that the lights themselves shouldn’t be seen…only their soft glow. As such, I try to make sure that I mount my LEDs in places where they will reflect off many surfaces and give the nicest ambient light. Skill Level 3 of 5 Time Required 1-1 1/2hrs. Tools […]
Altima Coupe Bumper Removal
Altima Coupe Bumper Removal This is used for reference on installing an aftermarket HID kit on your Altima Coupe. This step is needed for the installation Step One: Gather your tools. You will need a Phillips and a small flat-head screwdriver. Step Two: Open Hood. There will be 8 clips on the top of the […]
Altima Manually Pull and Read Check Engine Light Codes CEL/SES
This article shows you how to read/pull the fault codes, usually accompanied by a Check Engine Light or Service Engine Soon, on your Altima with push button start. You do not need an OBDII code reader or any other special tools to do this. To take a reading without using an OBD II reader, you […]
- 1
- 2
- 3
- …
- 5
- Next Page »