You will need: 600 sand paper (wet or dry your choice) Dupilcolor Engine Enamel and Clear Coat( I chose not to clear as the final coat came out pretty smooth) Start by cleaning the cover with some dish detergent and a scrub brush to remove dirt and oil. Don’t bother drying it as the next […]
Simple Portable GPS or Radar Detector Install Tutorial
Ok, so here is a quick way to install a portable GPS unit into your car w/ out needing to cut or tap into any factory wires and no need to buy a hard wire GPS cable (use your original cable). You can also do the same thing for a radar detector. It also takes […]
Removing Altima Coupe Door Panels
Ok, how to remove door panels. Here we go: First, pry off the cover inside the door handle. Then unscrew the screw inside. Now, pry up the cover starting from the bottom. Once unclipped, undo the wire connection. Then place the assembly aside. Now pry off the trim peace, starting from the rear, and moving […]
Altima Coupe Removing Seats and Carpet for Sound Dampening Install
So I finally found the time to tear apart the A/C and apply the B-Quiet material to the car. I honestly cannot believe how huge a difference this made. There’s a patch of bricks down the street from my house I drive over every day, and after the install I didn’t hear the bricks under […]
Versa Windshield Wiper Arm and Cowl Replacement
This how to guide shows you how to replace the windshield wiper arm and cowl on a Nissan Versa. Recently, my girlfriends new Versa was damaged when a dead tree branch fell on it one windy night. We had the glass replaced a day or two later and recently got the new parts (cowl and […]
Q45 Performance Modifications Overview
Q45 PerformanceBy Wes Stinson, Technical Advisor Feel free to contact me with any questions about any of the things on this article. So, you want to make your Q better?You want to make it faster, handle better, and make it look sharper.Despite what you may think, it is much easier than you think. This is […]
Altima Manually Pull and Read Check Engine Light Codes CEL/SES
This article shows you how to read/pull the fault codes, usually accompanied by a Check Engine Light or Service Engine Soon, on your Altima with push button start. You do not need an OBDII code reader or any other special tools to do this. To take a reading without using an OBD II reader, you […]
Technical Articles: G35- How to:Reset ECU, Throttle Pedal Release & Idle Air Volume Learning
How to reset your ECU and perform the Throttle Pedal Release and Idle Air Volume Learning procedures on an Infiniti G35 and the Nissan 350Z. Before attempting any of the following procedures, it is advisable that you read through the instructions thoroughly and familiarize yourself with them. A stop watch or an analog clock with […]
Altima Coupe How to Install Sequential Turn Signals
How to Install Sequential Turn Signals This article shows you how to install Oznium Orange flexible LED strips to be used as sequential turn signals on your Nissan Altima. Ok Guys and Girls, I had to do it! Especially since I told LBC about it. The whole process takes about 4 hours to do. Probably […]
Q45 Fog Light Modification
Fog Light Modification Infiniti Fourth Generation Q45 Wiring Relays Tools Electrical Battery Cable Yellow Customize Personal Soldering Wire Taps Crimping Splicing Strippers Connectors Bundle Cut Strip Shock Short Jumper I thought I had done this already, but could not find it. I am doing it over due to requests I keep getting of how to […]
- « Previous Page
- 1
- …
- 97
- 98
- 99
- 100
- 101
- …
- 152
- Next Page »